Weider Pro 9020 English Manual - Page 10

Attach a Weight Guide 29 to the Weight Stack

Get Weider Pro 9020 PDF manuals and user guides View all Weider Pro 9020 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

6. Orient the Weight Guides (29) so that the indicated holes are in the locations shown. 6 Attach a Weight Guide (29) to the Weight Stack Base (109) with an M10 x 65mm Bolt (85), two M10 Washers (93), a 13mm Spacer (86), and an M10 Locknut (84); do not tighten the Bolt yet. Attach the other Weight Guide (29) in the same way. Holes 29 84 93 29 86 93 85 109 7. Slide two Round Weight Bumpers (48) onto each Weight Guide (29). Next, slide fourteen Weights 7 (30) onto the Weight Guides. Insert the Weight Selector (28) into the stack of Weights (30). Make sure that the pin on the Weight Selector sits in the groove in the top Weight. Press the Plastic Bushing (52) into the center hole in the fifteenth Weight (30). Then, slide the Weight onto the Weight Guides (29); make sure that the Plastic Bushing is turned so that one of the slots slides over the pin on the Weight Selector (28). Pin 29 Groove 52 Slot 30 28 29 30 48 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
10
6
7
29
86
93
85
109
29
Holes
52
30
28
29
29
30
48
84
93
6.
Orient the Weight Guides (29) so that the indi-
cated holes are in the locations shown.
Attach a Weight Guide (29) to the Weight Stack
Base (109) with an M10 x 65mm Bolt (85), two
M10 Washers (93), a 13mm Spacer (86), and an
M10 Locknut (84);
do not tighten the Bolt yet.
Attach the other Weight Guide (29) in the
same way.
7.
Slide two Round Weight Bumpers (48) onto each
Weight Guide (29). Next, slide fourteen Weights
(30) onto the Weight Guides.
Insert the Weight Selector (28) into the stack of
Weights (30).
Make sure that the pin on the
Weight Selector sits in the groove in the top
Weight
.
Press the Plastic Bushing (52) into the center
hole in the fifteenth Weight (30). Then, slide the
Weight onto the Weight Guides (29);
make sure
that the Plastic Bushing is turned so that one
of the slots slides over the pin on the Weight
Selector (28).
Groove
Pin
Slot