Weider Pro 9020 English Manual - Page 16

Locate Cable B 64.

Get Weider Pro 9020 PDF manuals and user guides View all Weider Pro 9020 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

18. Attach the Lat Bar Bracket (15) to the Left Upright (14) with two M10 x 68mm Bolts (98) 18 and two M10 Washers (93). 98 93 14 15 19. See the CABLE DIAGRAMS starting on page 40 to identify the cables. 19 Locate Cable B (64). Hold the ends of Cable B near the center of the Butterfly Arm (23) as shown. Locate the two wire ties in the center of the Butterfly Arm (23). Tie one wire tie to each end of Cable B (64) as shown. Next, pull the other ends of the wire ties until Cable B is routed through the Butterfly Arm. Then, remove and discard the wire ties. Make sure to leave a loop of cable extending from the center of the Butterfly Arm. See the inset drawing. Insert the ends of Cable B (64) through the two Swivel Brackets (24). Make sure that the ends of Cable B are under the rods in the Swivel Brackets. Next, press the Swivel Brackets into the Butterfly Arm (23). 64 Wire Ties 23 Loop 24 64 Rod 24 23 16

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
16
18
19
15
23
Wire
Ties
64
Loop
14
98
93
18. Attach the Lat Bar Bracket (15) to the Left
Upright (14) with two M10 x 68mm Bolts (98)
and two M10 Washers (93).
19.
See the CABLE DIAGRAMS starting on page
40 to identify the cables.
Locate Cable B (64).
Hold the ends of Cable
B near the center of the Butterfly Arm (23) as
shown.
Locate the two wire ties in the center of the
Butterfly Arm (23). Tie one wire tie to each end of
Cable B (64) as shown. Next, pull the other ends
of the wire ties until Cable B is routed through
the Butterfly Arm. Then, remove and discard the
wire ties.
Make sure to leave a loop of cable
extending from the center of the Butterfly
Arm.
See the inset drawing.
Insert the ends of Cable
B (64) through the two Swivel Brackets (24).
Make sure that the ends of Cable B are under
the rods in the Swivel Brackets.
Next, press
the Swivel Brackets into the Butterfly Arm (23).
23
24
Rod
24
64