Weider Pro 9020 English Manual - Page 25

See the inset drawing.

Get Weider Pro 9020 PDF manuals and user guides View all Weider Pro 9020 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

39. Route Cable D (66) over a Pulley (46). Attach the Pulley (46) to the Left Upright (14) with an M10 x 45mm Bolt (95) and an M10 Locknut (84). 39 84 14 95 46 66 40. Route Cable D (66) through the bracket on the Weight Stack Top (13) and over a Pulley (46). 40 Attach the Pulley (46) to the Weight Stack Top (13) with an M10 x 45mm Bolt (95) and an M10 Locknut (84). 13 84 95 46 66 41. Set the Weight Selector Bumper (50) on the Weight Selector (28). 41 Next, insert the end of Cable D (66) into the Weight Selector Bumper (50) and the Weight Selector (28). See the inset drawing. Locate the bolt (A) attached to the Weight Pin (53). Insert the bolt (A) through the Weight Selector Bumper (50), the Weight Selector (28), and the end of Cable D (66). Then, tighten an M10 Locknut (84) onto the end of the bolt. 25 84 66 50 A 28 A 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
25
39
40
41
95
14
84
46
95
84
A
84
66
46
66
39. Route Cable D (66) over a Pulley (46).
Attach the Pulley (46) to the Left Upright (14)
with an M10 x 45mm Bolt (95) and an M10
Locknut (84).
40. Route Cable D (66) through the bracket on the
Weight Stack Top (13) and over a Pulley (46).
Attach the Pulley (46) to the Weight Stack Top
(13) with an M10 x 45mm Bolt (95) and an M10
Locknut (84).
41. Set the Weight Selector Bumper (50) on the
Weight Selector (28).
Next, insert the end of Cable D (66) into the
Weight Selector Bumper (50) and the Weight
Selector (28).
See the inset drawing.
Locate the bolt (A)
attached to the Weight Pin (53).
Insert the bolt (A) through the Weight Selector
Bumper (50), the Weight Selector (28), and
the end of Cable D (66). Then, tighten an M10
Locknut (84) onto the end of the bolt.
66
13
53
A
50
28