Xerox 2135N Quick Reference Guide - Page 115
Top cover inner frame and front/rear top cover spring, assembly
![]() |
UPC - 042215474689
View all Xerox 2135N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Top cover inner frame and front/rear top cover spring assembly Warning Switch off the power and disconnect the power cord. 1. Open the top cover. Remove the drum/toner cartridges. Place them in a lightproof black bag to protect the drum units from light and store in a safe place. 2. Remove the left-side cover as detailed on page 91. 3. Remove the front cover as shown in "Front cover" on page 90. 4. Remove the front shield plate (five gold screws and 3 black screws). 5. Remove the rear shield plate as shown on page 97. 6. Remove the four screws securing the top shield plate to the electrical card cage. 7. Remove the top shield plate. 8. Disconnect the nine LED flat wiring harnesses from the print engine controller board. 9. Remove the four screws securing the cable shield to the top of the electrical card cage. Free the flat wiring harnesses from the card cage. 10. Disconnect the top cover inner frame's wiring harness interconnects located next to the rear hinge. 11. Remove the five screws securing the rear top cover damper. Tilt the top cover forward slightly and remove the damper. 12. Remove the five screws securing the front top cover damper. Tilt the top cover forward slightly and remove the damper. 13. Supporting the weight of the top cover inner frame, gently lower the inner frame into its closed position. 14. Carefully slide the inner shaft sideways to free it from the printer. The two top cover hinge springs will be freed as the shaft is remove. 15. Remove the top cover inner frame. Caution Set up-side down on a flat surface to protect the LED assemblies from damage. 102 Phaser 2135 Color Printer
![](/manual_guide/products/xerox-2135n-quick-reference-guide-72fa279/115.png)