Xerox 2135N Quick Reference Guide - Page 53
Wrong media, Paper jams at the paper tray
UPC - 042215474689
View all Xerox 2135N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Jams Wrong media 1. Ensure the correct media type and size is loaded in the correct tray. For the multi-sheet bypass feeder, ensure the loaded media matches the control panel settings. 2. Inspect the paper tray for damage to the tray's paper size sensor actuators. 3. Test the printer's paper size sensors using the service test "Switch scan test" on page 63. If the sensors test ok, then the engine controller board is probably bad. 4. Replace the paper size sensor board's wiring harness. Paper jams at the paper tray 1. Is the paper in good condition and appropriate for a laser printer? 2. Is the printer printing within its environmental specifications? Print the Diagnostic Summary Page to determine the printer's environmental conditions. 3. Are the pick rollers dirty? If so, clean them if debris is visible and try printing again. 4. Remove the paper tray and inspect the paper tray lift levers on the inner-sides of the paper tray cavity. Inspect the tray's paper lift mechanism. 5. Does the paper feed motor run? Check the motor's wiring harness and connection (HOPFF) to the engine controller board. 6. Replace the main feeder assembly (it contains the paper feed motor). 7. Check the gear train for broken teeth and proper installation. 8. Replace the pick rollers. 9. Does the pick clutch work properly? If not, replace it. 10. Replace the engine controller board. 40 Phaser 2135 Color Printer