Bosch WTMC5321US Installation and Use & Care (all languages) - Page 20
Troubleshooting - repair
UPC - 825225852339
View all Bosch WTMC5321US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Troubleshooting d WARNING d TO AVOID RISK OF ELECTRICAL SHOCK! Repairs or replacement of parts may be carried out by authorized technicians only. Before calling the customer service, check whether you can rectify the fault yourself by means of the following table. If a fault cannot be rectified or a repair is required: 1. Set program selector to Off". 2. Turn off the circuit breaker. 3. Pull the main plug out of the socket. 4. Call customer service (see page 21). Problem Possible cause Remedial action Dryer does not start. Start/Stop" indicator light does not illuminate. Program has been interrupted. A warning signal is emitted and the display shows E:01". Main plug not inserted at all or not inserted correctly. A fuse of power supply has tripped. Start/Stop" button not pressed. No program selected. Door not closed. Ambient temperature below 41 °F/5 °C. Lint filter dirty. Exhaust air duct is blocked or too long. Insert main plug correctly. Replace/switch on fuse. Press Start/Stop" button. Select program. Close door. Increase room temperature. Clean filter as described on page 18. Switch off/switch on again. Clean exhaust air duct. Reduce exhaust air duct to maximum length as described on page 8. Switch off/switch on again. Fault in program sequence or malfunction. Switch off dryer, leave to cool down for 30 min, switch on again. Restart program. The room/cabinet is not adequately ventilated. Degree of drying has not been reached Moisture sensor dirty. or the drying time is too long. Display may indicate E:03". Exhaust air duct is blocked or too long. Provide an adequate supply of fresh air. Switch off/switch on again. Clean moisture sensor as described on page 18. Switch off/switch on again. Clean exhaust air extraction. Reduce exhaust air duct to maximum length as described on page 8. Switch off/switch on again. Lint filter dirty. Laundry was too wet. Unsuitable program selected. Maximum drying time was exceeded. Clean filter as described on page 18. Switch off/switch on again. Spin laundry at higher speed in the washing machine. Switch off/switch on again. Select program with aid of the program selection table (see page 15). Switch off/switch on again. Clean lint filter (see page 18). Check exhaust air extraction. Spin laundry at a higher speed in your washer. Drum light does not function. Motor limit temperature was exceeded. No program selected. Light bulb defective, light bulb burned out. No power supply. Light bulb is loose. Switch off dryer, leave to cool down for 30 min. Switch on again. Start program. Select program. Change light bulb, see page 19. Guarantee power supply. Tighten light bulb. Remove and reinstall the cover as directed on page 24. Start/Stop" indicator light does not illuminate. Wrinkle block" indicator lights. The display shows 000". Lint filter LED is blinking after lint filter has been cleaned Fault in program sequence or malfunction. Blinking of lint filter LED is not an indication of a problem. It is used only as a reminder. Switch off dryer, leave to cool down for 30 min, switch on again. Restart program. No action required. Light will stop blinking. 20