Bosch WTMC5321US Installation and Use & Care (all languages) - Page 9
Installation
UPC - 825225852339
View all Bosch WTMC5321US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Installation ć step by step 1. Unpack the dryer. 2. Remove all objects from the drum. 3. Check the dryer for visible damage. 4. Position the dryer near the installation location. 5. If required, change the door hinges to the left (see page 5). 6. If required, have customer service install the exhaust air outlet on the dryer (see page 7). 7. Have the power supply cord fitted by an authorized technician (see page 6). 8. Install exhaust duct if necessary. Follow the installation instructions supplied by the appropriate manufacturer! i If space is very restricted, it is recommended to fit the initial parts of the exhaust duct to the dryer before the dryer is moved to its final installation location. 9. Move the dryer to its final location and align. ATTENTION Do not slide dryer across the floor if heightĆadjustable feet have been extended. Feet and/or dryer base may be damaged if dryer is slid across floor with heightĆadjustable feet extended. 10. Position and then level the dryer. The dryer should be level with all four feet firmly on the ground. The dryer must not wobble. If the dryer is not level or if it does wobble, the feet must be adjusted. Adjust the heightĆadjustable feet until the dryer does not rock and is level, both frontĆtoĆback and sideĆtoĆside. 11. Connect the exhaust duct to the exhaust air outlet on the dryer. 12. Insert plug into the wall receptacle. Check list before using the dryer 1. Check that steps 1-12 have been implemented properly. 2. Ensure that the dryer is connected to the power supply. 3. Read the operating instructions to understand how your dryer operates. 4. Conduct an appliance test: q Check that the drum is empty. q Close the dryer door. q Switch the dryer to "Extra Dry" and then press the Start button. q After 3-5 minutes press the Stop button and open the door. 5. If the interior of the dryer feels warm, the dryer has been connected properly. Switch the dryer to "OFF". 6. If the dryer does not work, switch the dryer to "OFF". Look in the troubleshooting section (page 20) of the OPERATING INSTRUCTIONS and find the fault. Preparing to transport the dryer ć step by step 1. Rotate the program selector to "OFF". 2. Pull out the power supply plug. 3. Disconnect the exhaust duct from the exhaust air outlet on the dryer. 4. Place any accessories in the drum. 5. Close the door and secure with adhesive tape. 6. Screw the heightĆadjustable feet of the dryer into the housing to prevent them from being damaged during transportation. 9