Bosch WTMC5321US Installation and Use & Care (all languages) - Page 5
Caution, Attention, Warning - venting
UPC - 825225852339
View all Bosch WTMC5321US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Old appliances are not worthless rubbish! Valuable raw materials can be reclaimed from environmentally friendly recycling. Please ask your dealer or inquire at your local authority about the current means of disposal. Before installing the dryer Unpacking the appliance d CAUTION The dryer is very heavy. Do not lift it by yourself. Do not lift the appliance by projecting components (e.g. door) ć due to risk of breakage. ATTENTION Remove the appliance packaging carefully to prevent damage to the surfaces. Check the dryer for transportation damage. Do not connect a dryer which is visibly damaged. If in doubt, contact your dealer. Supplied components For U.S.A. d CAUTION The dryer is supplied without a power cord. The power cord must be connected by qualified persons only. Installation location d WARNING d Do not install the dryer: - outdoors - in an environment with dripping water, - near flammable materials, - in rooms which are at risk of frost, - in rooms which may contain gas or other fuels, - in cupboards with lockable doors or in alcoves. The installation room must be well ventilated, otherwise the dryer will operate below optimum performance. Do not operate the dryer at temperatures above 104°F (40°C) and below 41°F (5°C). Low temperatures affect the automatic program sequence and may prolong the drying times. The installation surface for the dryer must be clean, level and firm. Do not install the appliance on carpets! Compensate for uneven floors with the heightĆadjustable feet. Install the dryer and level side to side and front to back. Use a bubble level. Never remove the heightĆadjustable feet! The size of the installation area depends on the dimensions of the dryer. Ensure that there is adequate room for the swivel range of the door! Minimum Installation Clearances Closet Sides 0" (O mm) Top 12" (3O5 mm) Rear* 0" (O mm) * as close to wall as venting will allow. Important information concerning minimum distances: - Depending on the location of the exhaust air connection, an additional minimum distance of 5½ inch (14 cm) must be provided on this side for pipes/brackets (see page 7). - Distances above the indicated minimum dimensions reduce the risk of mold formation behind the appliance. - Additional distances reduce noise transmission. - Additional distances facilitate installation and service. - If the dryer is installed in a small room, the doors of the room must be fitted with vents of a specified minimum size. ATTENTION After removing the packaging, immediately remove any objects from the drum. The dryer is delivered as a complete unit. The operating instructions and supplied accessories can be found in the drum. Dimension Weight a 27.0" (686 mm) 125 lbs b 31.8" (808 mm) (56 kg) with c 37.2" (945 mm) packaging d 19.7" (500 mm)/ 143 lbs angle 170 - 180° (64 kg) If installing the dryer in a closet, observe the minimum distances according to the following table: The dryer door is delivered with hinges on the right. If required, the door hinges can be switched to the left side. If the door hinges are to be changed over, please contact your dealer or our customer serviceĆteam (see page 21) 5