Brother International BAS-375E Programmer Instruction Manual - English - Page 139
Inputting the end code, Saving, Ending program, Multiple stitch, Creating a stitch pattern
View all Brother International BAS-375E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Chapter 3 Programming with Command Function Inputting the end code 1. Press 1 1 1 E . The work clamp returns to the start position. Saving 1. Specify the program number on the operation panel and press the read/write switch for writing into the floppy disk. Ending program 1. Press P . Multiple stitch This section describes programming of a multiple stitch. Refer to the example on the left. Programming can be started from either inside or outside line. Embroidering is carried out in the sequence of programming. Embroidering direction depends on programming sequence. When embroidering direction should be changed at a sharp angle, a split should be provided in the vicinity of the direction change point for finishing the multiple stitch in relatively uniform conditions. Up to 200 points can be specified for one side. If you attempt to input 201 or more points, the needle point is automatically returned to the previous points. In that case, start inputting points of the outside (or the inside) line, or reconsider point input positions or pattern. Creating a stitch pattern 1. Create a pattern in consideration of the most inside and outside lines for a multiple stitch. The two lines should be spaced uniformly. 138 Programmer Should be spaced uniformly. Outside line Inside line