Brother International BAS-375E Programmer Instruction Manual - English - Page 173

Chapter 3 Programming with Command Function Modifying the program of a multiple stitch When modifying the stitch length or the number of lines for a multiple stitch, the previously created curve program can be used. The previously created programs are required for modifying programs of multiple stitch. Programs of multiple stitch written to floppy disks cannot be modified. Commands to be used 5 M M Input the number of lines for a multiple stitch ranging from 2 to 99 in . Ex.) The number of lines for a multiple stitch 5 lines Input value 505 Input the stitch length in . 1. Press R . The work clamp moves to the home position. 2. Press 9 9 9 . The needle point moves. When the needle point is at the start point for a multiple stitch, stop it by pressing . 3. Input the desired number of lines as 5 M. 4. Input the desired stitch length as M. 5. Press L . Calculation is performed based on the input data. When a buzzer stops, the needle point moves to the end point for a multiple stitch. 172 Programmer