Brother International Innov-ís 80 Users Manual - English - Page 135
Nothing appears in the LCD, Operation beep, Cancelling the operation beep
View all Brother International Innov-ís 80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 135 highlights
APPENDIX Nothing appears in the LCD If nothing appears in the LCD when the sewing machine is turned on, the brightness of the LCD is either too light or too dark. If this is the case, perform the following operation. Turn off the sewing machine. a Cancelling the operation beep When the sewing machine is purchased, it is set to beep each time an operation panel key is pressed. This setting can be changed so that the machine does not beep. Turn on the sewing machine. a While pressing (Cancel/clear key) in the b operation panel, turn on the sewing machine. Press or (Stitch width keys). c Adjust the brightness of the LCD so that the screens can be seen. X The LCD comes on. Press b panel. (Settings key) in the operation X The settings screen appears. Press or (Stitch length keys) until is c displayed. Turn off the sewing machine, then turn it on d again. Operation beep Each time a key is pressed or an incorrect operation is performed, a beep is sounded. ■ For a correct operation One beep is sounded. ■ If an incorrect operation is performed Two or four beeps are sounded. ■ If the machine locks up, for example, because the thread is tangled The sewing machine continues to beep for four seconds. The machine automatically stops. Be sure to check for the cause of the error, and correct it before continuing to sew. X The screen for changing the beep setting appears. 134