Brother International Innov-ís 80 Users Manual - English - Page 82

■ If the button does not fit in the button guide plate Add together the diameter and thickness of the button, and then set the button guide plate to the calculated length. (The distance between the markings on the presser foot scale is 5 mm (3/16 inch).) Position the fabric with the front end of the e buttonhole mark aligned with the red marks on the sides of the buttonhole foot, and then lower the presser foot lever. 1 1 2 3 a Presser foot scale b Length of buttonhole (Diameter + thickness of button) c 5 mm (3/16 inch) Example: For a button with a diameter of 15 mm (9/16 inch) and a thickness of 10 mm (3/8 inch), the button guide plate should be set to 25 mm (1 inch) on the scale. A 2 a Mark on fabric b Red marks on buttonhole foot Pass the upper thread down through the hole in the presser foot. • When lowering the presser foot, do not push 3 in the front of the presser foot, otherwise the buttonhole will not be sewn with the correct size. a 1 a Do not reduce the gap. 2 a 10 mm (3/8 inch) b 15 mm (9/16 inch) X The size of the buttonhole is set. Pull down the buttonhole lever as far as f possible. a Attach buttonhole foot "A". c • For details, refer to "Replacing the presser foot" (page 41). Select a stitch. d • For details, refer to "Selecting stitching" (page 67). a Buttonhole lever The buttonhole lever is positioned behind the bracket on the buttonhole foot. 1 2 a Buttonhole lever b Bracket Buttonhole Stitching/Button Sewing 81