Brother International MFC-P2000 Service Manual - Page 198

USER'S GUIDE Test Print Mode The machine has the following test print mode. Follow these steps: 1. Make sure that the top cover is closed. 2. Hold down the switch and turn on the power switch. Keep the switch depressed until the Drum lamp comes on. The Drum lamp lights to indicate that the machine is in the test print mode. 3. Press the switch again to execute the test print or hold down the switch to select another option and release the switch to execute the selected option. The test print modes are listed below: Lamp Lit Drum Alarm Ready Data Choice Test sample page Print Config & Print Fonts I Factory Reset Hex Dump Print Function The machine prints a test sample page. The machine returns to the ready status after printing. The machine prints the current configuration of the machine and a list of the internal fonts. The machine returns to the ready status after printing. The machine is restored to the factory setting and permanent fonts and macros are cleared. The machine returns to the ready status after printing. The machine can print data as hexadecimal values, so that you can check data errors and problems. To exit from this mode, you have to turn off the machine. 3-4