Brother International MFC-P2000 Service Manual - Page 57

Halogen heater lamp (Blue 100V, Red 200V) Heat Roller Bearing Heat Roller Washer Retaining ring Heat roller gear Groove Heat roller Taptite, pan M3x10 Idle gear 16 Taptite, pan M3x10 Connector plate Fixing unit frame Heat Roller Bearing Fig. 3-22 Note:
When reassembling the heat roller bearings, ensure that the direction of the bearing is correct referring to Fig. 3-22.
The heat roller itself is very similar to the one for HL-1060/1070 printers. The heat roller for the MFC-P2000 / HL-P2000 printer can be distinguished by the groove on the edge of the roller. (Refer to Fig. 3-22.)
When replacing the heat roller cleaner with a new one, attach the cleaner referring to the figure below; -1 mm ~ +1 mm 4 mm ~ 5 mm Fig. 3-23
Follow the instructions below when installing the thermistor in the fixing unit. i) Place the cleaner felt of the cleaner ASSY for the thermistor under the heat roller. ii) Place the end of the thermistor on the heat roller. iii) Insert boss1 of the thermistor into the hole of the fixing unit frame. iv) Do no place the thermistor on boss2 of the fixing unit frame. , , Boss2 Thermistor Heat Roller Boss1 , , , Cleaner ASSY for thermistor Fixing unit frame ,,,,,,,, Fig. 3-24 III-16