Brother International MFC-P2000 Service Manual - Page 47
The spring easily comes off from the actuator., ensure that the direction of the spring is correct.
UPC - 012502525394
View all Brother International MFC-P2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
PR98242 (5) Remove the M3x6 pan tapping screw securing the front spring plate, washer, separation rubber and ADF spring plate, then remove all of them. Note that the vibration proof rubber is attached to the back of the ADF spring plate. (6) Press one side of the document pressure bar inwards to remove it. The spring will be released and should also be removed. (7) Remove the document rear sensor actuator . Taptite, pan M3x6 Front Spring Plate Washer Separation Rubber Vibration Proof Rubber ADF Spring Plate Document Pressure Bar Spring Document Rear Sensor Actuator Fig. 3-6 (8) Remove the six M3x8 tapping screws from the panel rear cover. (9) Release the four hooks to remove the panel rear cover. (10) Remove the document front sensor actuator with the helical torsion spring . Note: Do not lose the helical torsion spring when disassembling the document front sensor actuator. The spring easily comes off from the actuator. When reassembling the helical torsion spring to the document front sensor actuator, ensure that the direction of the spring is correct. Assemble the document front sensor actuator while lightly pressing it. Then check that the document front sensor works correctly by turning ON/OFF the sensor with the actuator. III-6