Brother International MFC-P2000 Service Manual - Page 232
Q & A, Setting up the Machine Hardware
UPC - 012502525394
View all Brother International MFC-P2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 232 highlights
USER'S GUIDE Q & A This section contains questions and answers for using your machine. If you have encountered a problem, find the question relating to your problem and take the steps recommended to correct the problem. Setting Up the Machine Hardware Question The machine does not work. All lamps are off. The machine does not print. Recommendation The machine may be in sleep mode. Press the panel switch to wake up the machine. Check to see if the machine is plugged into a live power source and the power switch is on. Check the following: The machine is turned on. All of the protective parts have been removed. The toner cartridge and drum unit are installed properly. The interface cable is securely connected between the machine and computer. Check to see if the Alarm lamp is blinking. If the lamp is blinking, refer to the Operator Call section of this manual. Check to see if the Ready lamp is blinking. If the lamp is blinking fast, the machine might be cooling down to lower the machines internal temperature. Open the top cover of the machine to lower the temperature. Setting Up the Machine for Windows Question I cannot print from my application software. Sometimes I get a Memory Full message. How can I correct this? Sometimes I get a Print Overrun error when printing certain documents from Windows. Recommendation Make sure the supplied Windows printer driver is installed and selected with your application software. Reduce the print resolution or reduce the complexity of your document and try again. If you are using the supplied Windows driver, turn error recovery on in the Setup dialog box and try again. Reduce the print resolution or reduce the complexity of your document and try again. 7-10