Canon EOS C200B EOS C200 EOS C200B Instruction Manual - Page 136

Custom Picture Settings 136 Submenu levels / Menu items [Level Depend Slope] [Level Depend Offset] [Noise Reduction] [Level] [White Balance] [R Gain], [B Gain] [Color Matrix Tuning] [Gain] [Phase] [R-G], [R-B], [G-R], [G-B], [B-R], [B-G] [Other Functions] [Setup Level] [Over 100%] Options / Additional information 0 (no slope), 1 (steep slope) to 3 (gradual slope) (0) Determines the slope of the area between the upper and lower parts of the gamma curve. 0 to 50 (0) Adjusts the sharpness level of dark areas in the image. Setting higher values will lower the sharpness level. 1 (lowest level) to 12 (highest level), [Off] Reduces the amount of noise that appears in the image. -50 to 50 (±0) These settings adjust the amount of white balance throughout the whole image by changing the intensity of red tones ([R gain]) and blue tones ([B Gain]). -50 to 50 (±0) -18 to 18 (±0) These settings adjust the color intensity ([Gain]) and color phase ([Phase]) of the color matrix, affecting the color tones of the whole image. -50 to 50 (±0) Each matrix changes the tint of the picture along the color gradations detailed below, affecting the color tones of the whole image. [R-G]: cyan/green and red/magenta; [R-B]: cyan/blue and red/yellow; [G-R]: magenta/red and green/cyan; [G-B]: magenta/blue and green/yellow; [B-R]: yellow/red and blue/cyan; [B-G]: yellow/green and blue/magenta. -50 to 50 (±0) Adjusts the black level set by the [Black] > [Master Pedestal] setting. When [Gamma] is set to one of the Canon Log settings, this setting has no effect on the picture. [Through], [Press], [Clip] Determines how the camera handles video signals exceeding 100%. [Through]: Leave the signal unchanged. [Clip]: Clip the signal at 100%. [Press]: Compress a signal of up to 108% down to 100% levels. NOTES • If editing of the custom picture file's detailed settings is enabled ([Activate Other Settings] is set to [On]), when an optional RC-V100 Remote Controller is connected to the camera, the following custom picture settings can be changed using the buttons and dials on the remote controller. - [Other Settings] > [Black] > [Master Pedestal], [Master Black Red], [Master Black Blue] - [Other Settings] > [Black Gamma] > [Level] - [Other Settings] > [Knee] > [Slope], [Point] (only when [Knee] > [Activate] is set to [On]) - [Other Settings] > [Sharpness] > [Level] - [Other Settings] > [White Balance] > [R Gain], [B Gain]