Canon EOS C200B EOS C200 EOS C200B Instruction Manual - Page 154
Setting the Scan Mode of the Output Signal, Open the [SDI/HDMI Scan Mode] submenu.
View all Canon EOS C200B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Connecting to an External Monitor or Recorder 154 Selecting the Output Signal in Mode When the camera is in terminal. mode, you can select the maximum resolution output from the HDMI OUT Operating modes: 1 Open the [HDMI Max Res.] submenu. > [B " System Setup] > [HDMI Max Res.] 2 Select [3840x2160] or [1920x1080] and then press the joystick. NOTES • The HDMI OUT terminal is for output only. Do not connect the camera to another device's output terminal using the HDMI OUT terminal as this will cause a malfunction. • Correct operation cannot be guaranteed when connecting the camera to DVI monitors. • Video may not be output correctly depending on the monitor. In such case, use another terminal. • You can set both > [3 $ Recording/Media Setup] > [Rec Command] and [HDMI Time Code] to [On] to use the camera's REC button to control also the recording operation of an external recorder connected to the HDMI OUT terminal. The camera's time code signal will be output as well. • The time code will not be output from the HDMI OUT terminal in the following cases. - During mode. - During SD output. - During slow motion recording. - During interval recording. - During frame recording. Setting the Scan Mode of the Output Signal You can set the scan mode of the video signal output from the SDI terminal or HDMI OUT terminal. Operating modes: 1 Open the [SDI/HDMI Scan Mode] submenu. 2 Select [P] or [PsF] and then press the joystick.