Canon EOS C200B EOS C200 EOS C200B Instruction Manual - Page 49
Inserting and Removing an SD Card, SD Card Access LED] to [Off], the SD card access
View all Canon EOS C200B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Preparing Recording Media Inserting and Removing an SD Card You can insert an SD card into SD card slot A or slot B. If you have two SD cards, you can use both slots. 1 Open the SD card slot cover. 2 Insert the SD card, with the label facing the right side of the camera (the side with the air intake vent), all the way into the SD card slot until it clicks. • To remove the SD card, make sure the SD access ብ ባ indicator is off and then push the SD card once to release it. When the SD card springs out, pull it all the way out. 3 Close the SD card slot cover. • Do not force the cover closed if the SD card is not SD card access indicator correctly inserted. 49 ቤ SD card access indicators SD CARD 2/ SD CARD 3 indicator SD card status Red Accessing the SD card. Green SD card is ready for recording, or playback of clips and photos is possible. An SD card is not inserted, the SD card is not being Off accessed, the SD card is write-protected with the LOCK switch, or the SD card slot is not currently selected. If you set > [B % System Setup] > [LED] > [SD Card Access LED] to [Off], the SD card access indicators will not illuminate. IMPORTANT • Observe the following precautions while an SD card access indicator is illuminated in red. Failure to do so may result in permanent data loss. - Do not disconnect the power source or turn off the camera. - Do not remove the SD card. • SD cards have front and back sides that are not interchangeable. Inserting an SD card facing the wrong direction can cause a malfunction of the camera. Be sure to insert the SD card as described in step 3. NOTES • SD cards have a physical switch to prevent writing on the card so as to avoid the accidental erasure of the card's content. To write-protect the SD card, set the switch to the LOCK position.