Canon EOS C200B EOS C200 EOS C200B Instruction Manual - Page 81

Adjusting the Focus Required settings on EF Cinema lenses To adjust the focus from the camera, you will need to change the focus mode using the controls on the lens. Required settings vary depending on the lens. Refer to the following table and the instruction manual of the lens used. Lens Part used on the lens Setting for automatic adjustment Setting for manual adjustment 81 EF lens Focus mode switch AF MF CN7x17 KAS S/E1 CN10x25 IAS S/E1 CN20x50 IAS H/E1 Focus operation change-over knob SERVO MANU. CN-E18-80mm T4.4 L IS KAS S Autofocus/Manual Focus AF MF CN-E70-200mm T4.4 L IS KAS S change-over switch Manual Focus Focus manually using the focus ring on the lens.You can also perform this function remotely using Browser Remote on a connected network device (A 170). The autofocus mode is set to [One Shot] by default. If you need to change the setting, start the procedure from the beginning. Otherwise, you can start from step 3 below. 1 Open the focus [AF Mode] submenu. > [v $ Camera Setup] > [AF Mode] 2 Select [One Shot] and then press the joystick. • On an EF lens, you can set the lens's focus mode switch to MF. On a compatible EF Cinema lens, enable manual adjustment on the lens (A 80). 3 Press the FOCUS GUIDE button to display the focus guide. • If you are not using the camera grip, you can alternatively set an assignable button to [Focus Guide] (A 125). 4 Turn the focus ring to adjust the focus. NOTES • With some EF lenses, you may be able to operate the focus ring even when the focus mode switch is set to AF. • If you operate the zoom after focusing, the focus on the subject may be lost. • If you focus manually and then leave the camera with the power turned on, the focus on the subject may be lost after a while. This possible slight shift in focus is a result of the internal temperature rising in the camera and lens. Check the focus before resuming shooting. • When adjusting the focus, be careful not to touch the front of the lens or moving parts on the lens except for the focus ring. • When an optional RC-V100 Remote Controller is connected to the camera, you can adjust the focus with the remote controller's FOCUS dial. At default settings, turn the dial right to focus farther and left to focus nearer.