Canon VB-M640VE Network Camera VB-R11VE/VB-R11/VB-R10VE/VB-M641VE/VB-M641V/VB- - Page 167

3 Under the lighting conditions of the Day Mode, adjust the focus position as required while watching the video. 4 Click [Register focus position] in the [Day/Night Mode Focus Settings] panel. [Registered] will appear in [Day Mode:]. 5 Switch Day/Night Mode to [Night Mode]. 6 Repeat steps 3 and 4 under the Night Mode lighting conditions to register the focus position. [Clear the registered focus position?] will appear if you select [Use One-shot AF] or [None], even if only one focus position has been registered for either [Day Mode] or [Night Mode]. If you select [No], the registered focus position will be retained even if you select to [Use One-shot AF] or [None]. Note See the following for the focus ranges when using Day/Night Mode settings. - "Focus Ranges" (P. 161) R11 R10 - The table in the "Note" section of "Set the Focus" (P. 55) M641 M640 M741 M740 5 Admin Viewer/VB Viewer Infrared M741 Set how infrared illumination is used. (1) (2) (3) (1) [Day/Night Operation] Linked to Day/Night. Turns on infrared illumination in Night Mode. (2) [Do not use] Infrared illumination is not used. (3) Infrared Illumination Strength Sets the infrared illumination strength when [Day/Night Operation] is selected. Important Infrared illumination strength can only be set when [Exposure] (P. 162) is set to [Manual]. Note If all or part of the image appears to have a white glow, there is a possibility that a wall (even a wall not in the image) is reflecting the infrared lighting. If this occurs, please adjust the camera angle. External Device Output R11 M641 M741 Use external device output. Click the icons to activate and deactivate output. Output status is shown by the icons. Screen Example: Output 1: inactive Output 2: active 167