Canon VB-M640VE Network Camera VB-R11VE/VB-R11/VB-R10VE/VB-M641VE/VB-M641V/VB- - Page 97

[Upload] Select whether to upload with HTTP or FTP. [Video Format] Select the video format for upload. [H.264(2)] cannot be used. Video size and quality of the uploaded video follow the settings in [Video Settings] (P. 72). Important For H.264(1), the following settings must be configured in [Video Settings] > [H.264(1)] (P. 73). - [Bit Rate Control]: [Use bit rate control] - [Target Bit Rate (kbps)]: [3072] or less - [I Frame Interval (sec)]: [0.5], [1] or [1.5] [Frame Rate] Enter the maximum frame rate of video to be uploaded when [Video Format] is set to [JPEG]. [Pre-event Buffer (number of frames)] (JPEG)/ [Pre-event Buffer (sec)] (H.264(1)) Enter the number of frames or seconds of video to be buffered before the event. Enter the maximum number of frames for [JPEG] or the maximum number of seconds for [H.264(1)] in [Video Format]. [Post-event Buffer (number of frames)] (JPEG)/ [Post-event Buffer (sec)] (H.264(1)) Enter the number of frames or seconds of video to be buffered after the event. Enter the maximum number of frames for [JPEG] or the maximum number of seconds for [H.264(1)] in [Video Format]. Important The maximum video buffer size capacity is approx. 5 MB. If a large video size is set, the Frame Rate, Pre-event Buffer and Post-event Buffer may not be achieved as specified. If buffering cannot be achieved as specified, a message is written to the log (P. 134). Confirm that no messages appear in the log. Note If the server or network load increases due to the upload settings, the video frame rate may drop. If this occurs, reconfigure the following settings to reduce the size and frequency of uploaded data. • Set a lower value for [Video Size: Upload / Memory card] for [JPEG] (P. 73). • Reduce the number of frames or seconds in [Pre-event Buffer] or [Post-event Buffer] (P. 97). • If [Volume Detection Event] is enabled, disable [ON Event Operation], [OFF Event Operation] or [Ongoing ON Event Operation] (P. 107). R11 M641 M741 • From the Intelligent Function Setting Tool [Event] tab, disable [ON Event Operation], [OFF Event Operation] or [Detected mode Operation] (P. 227). • If [External Device Input Event] is enabled, disable [Active Event Operation], [Inactive Event Operation] or [Ongoing Active Event Operation] (P. 105). R11 M641 M741 • If [Timer Event] is enabled, increase the value in [Repeat Interval] (P. 110). Setting Page 4 HTTP Upload Settings for the HTTP upload function when [Upload] is set to [HTTP Upload]. The HTTP upload function sends notifications via HTTP or via HTTP with attached videos, depending on the network camera event. For information about the HTTP upload function and settings, contact your nearest Canon Customer Service Center. 97