Dell OptiPlex 320 User Guide - Page 22
Back View, Back-Panel Connectors - manual
UPC - 683728237738
View all Dell OptiPlex 320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
10 CD/DVD drive Insert a CD or DVD (if supported) into this drive. 11 location of Service Tag Use the Service Tag to identify your computer when you access the Dell Support website or call technical support. Back View 1 card slots 2 back-panel connectors 3 power connector 4 voltage selection switch Access connectors for any installed PCI and PCI Express cards. Plug serial, USB, and other devices into the appropriate connector. See Back-Panel Connectors for details. Insert the power cable into this connector. Your computer is equipped with a manual voltage-selection switch. To help avoid damaging a computer with a manual voltage-selection switch, set the switch for the voltage that most closely matches the AC power available in your location. NOTICE: In Japan the voltage selection switch must be set to the 115-V position. Also, ensure that your monitor and attached devices are electrically rated to operate with the AC power available in your location. 5 padlock ring Insert a padlock to lock the computer cover. 6 cover release Use this latch to open the computer cover. latch Back-Panel Connectors 1 parallel connector Connect a parallel device, such as a printer, to the parallel connector. If you have a USB printer, plug it into a USB connector. 2 link integrity light NOTE: The integrated parallel connector is automatically disabled if the computer detects an installed card containing a parallel connector configured to the same address. For more information, see System Setup Options. l Green - A good connection exists between a 10-Mbps network and the computer. l Orange - A good connection exists between a 100-Mbps network and the computer. l Off - The computer is not detecting a physical connection to the network. 3 network adapter connector To attach your computer to a network or broadband device, connect one end of a network cable to either a network jack or your network or broadband device. Connect the other end of the network cable to the network adapter connector on the back panel of your computer. A click indicates that the network cable has been securely attached.