Dell OptiPlex 320 User Guide - Page 40
Power Supply - power supply replacement
UPC - 683728237738
View all Dell OptiPlex 320 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Back to Contents Page Power Supply Dell™ OptiPlex™ 320 User's Guide Replacing the Power Supply DC Power Connectors Replacing the Power Supply CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide. NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis. 1. Follow the procedures in Before You Begin. 2. Disconnect the DC power cables from the system board and the drives. Note the routing of the DC power cables underneath the tabs in the computer chassis as you remove them from the system board and drives. You must route these cables properly when you replace them to prevent their being pinched or crimped. 3. Remove the two screws that attach the power supply to the back of the computer chassis. 4. Remove the CD/DVD drive and carefully set it aside (see CD/DVD Drive). 5. Press the release button located on the floor of the computer chassis. 1 release button 2 power supply 3 screws (2) 4 AC power connector 6. Slide the power supply toward the front of the computer by approximately 1 inch. 7. Lift the power supply up and out of the computer. 8. Slide the replacement power supply into place. 9. Replace the screws that secure the power supply to the back of the computer chassis. 10. Reconnect the DC power cables.