Dell OptiPlex 7090 Small Form Factor Service Manual - Page 15

Intrusion switch, Removing the intrusion switch

Get Dell OptiPlex 7090 Small Form Factor PDF manuals and user guides View all Dell OptiPlex 7090 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Steps 1. Place the side cover onto the system aligning the tabs on the chassis. 2. Slide the side cover towards the front of the computer until you hear the release latch click. Next steps 1. Follow the procedure in after working inside your computer. Intrusion switch Removing the intrusion switch Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. About this task The following image indicate the location of the intrusion switch and provide a visual representation of the removal procedure. Steps 1. Press down on the latch on the intrusion switch cable and disconnect it from the connector on the system board. 2. Slide the intrusion switch and lift it away from the computer . Installing the intrusion switch Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. Removing and installing components 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
Steps
1.
Place the side cover onto the system aligning the tabs on the chassis.
2.
Slide the side cover towards the front of the computer until you hear the release latch click.
Next steps
1.
Follow the procedure in
after working inside your computer
.
Intrusion switch
Removing the intrusion switch
Prerequisites
1.
Follow the procedure in
before working inside your computer
.
2.
Remove the
side cover
.
About this task
The following image indicate the location of the intrusion switch and provide a visual representation of the removal procedure.
Steps
1.
Press down on the latch on the intrusion switch cable and disconnect it from the connector on the system board.
2.
Slide the intrusion switch and lift it away from the computer .
Installing the intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
15