Dell OptiPlex 7090 Small Form Factor Service Manual - Page 62
Next steps, Install
View all Dell OptiPlex 7090 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
● SATA power cable ● System fan cable 4. Place the metal bracket in position over the system board and front chassis, and install the two (6-32) screws. 5. Route the SATA cables along the cable routing guide on the metal bracket. 6. Align and lower the I/O panel into the slot on the chassis. 7. Replace the screws (6-32) to secure the I/O panel to the chassis. Next steps 1. Install the processor. 2. Install the fan assembly. 3. Install the WLAN card. 4. Install the solid-state drive. 5. Install the memory modules. 6. Install the graphics card. 7. Install the 2.5/3.5-inch hard-drive caddy. 8. Install the side cover. 9. Follow the procedure in after working inside your computer. 62 Removing and installing components
●
SATA power cable
●
System fan cable
4.
Place the metal bracket in position over the system board and front chassis, and install the two (6-32) screws.
5.
Route the SATA cables along the cable routing guide on the metal bracket.
6.
Align and lower the I/O panel into the slot on the chassis.
7.
Replace the screws (6-32) to secure the I/O panel to the chassis.
Next steps
1.
Install the
processor
.
2.
Install the
fan assembly
.
3.
Install the
WLAN card
.
4.
Install the
solid-state drive
.
5.
Install the
memory modules
.
6.
Install the
graphics card
.
7.
Install the
2.5/3.5-inch hard-drive caddy
.
8.
Install the
side cover
.
9.
Follow the procedure in
after working inside your computer
.
62
Removing and installing components