Dell OptiPlex 7090 Small Form Factor Service Manual - Page 22

Installing the 2.5-inch hard-drive, Steps, Next steps, Prerequisites, About this task

Get Dell OptiPlex 7090 Small Form Factor PDF manuals and user guides View all Dell OptiPlex 7090 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Steps 1. Place the tabs on the right side of the hard-drive caddy onto the holders on the chassis and push the left side of the caddy down until it clicks into place. NOTE: Use the arrows seen on the caddy as guides to identify the tabs on the tray. 2. Connect the hard-drive data and power cables to the connectors on the hard drive. Next steps 1. Install the front bezel. 2. Install the side cover. 3. Follow the procedure in after working inside your computer. Installing the 2.5-inch hard-drive Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image shows the hard-drive and provides a visual representation of the installation procedure. 22 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
Steps
1.
Place the tabs on the right side of the hard-drive caddy onto the holders on the chassis and push the left side of the caddy
down until it clicks into place.
NOTE:
Use the arrows seen on the caddy as guides to identify the tabs on the tray.
2.
Connect the hard-drive data and power cables to the connectors on the hard drive.
Next steps
1.
Install the
front bezel
.
2.
Install the
side cover
.
3.
Follow the procedure in
after working inside your computer
.
Installing the 2.5-inch hard-drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image shows the hard-drive and provides a visual representation of the installation procedure.
22
Removing and installing components