Dell OptiPlex 7090 Small Form Factor Service Manual - Page 26
Installing the M.2 2280 solid-state drive
View all Dell OptiPlex 7090 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Steps 1. Unroute the SATA cable from the routing guide on metal bracket. 2. Remove the two (6x32) screws securing the metal bracket and lift it away from the system. 3. Remove the screw (M2x3) that secures the solid-state drive to the system board. 4. Slide and lift the solid-state drive off the system board. Installing the M.2 2280 solid-state drive Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the installation procedure. 26 Removing and installing components
Steps
1.
Unroute the SATA cable from the routing guide on metal bracket.
2.
Remove the two (6x32) screws securing the metal bracket and lift it away from the system.
3.
Remove the screw (M2x3) that secures the solid-state drive to the system board.
4.
Slide and lift the solid-state drive off the system board.
Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the
installation procedure.
26
Removing and installing components