Dell OptiPlex 7090 Small Form Factor Service Manual - Page 31
Removing the slim optical-drive, Steps, Next steps, Prerequisites
View all Dell OptiPlex 7090 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Steps 1. Connect the power and SATA cables to the optical drive while holding the bracket upside down. 2. Hold the bracket upright and align the mounting points with the ones on the chassis. 3. Push the bracket until the assembly is secured onto the chassis. 4. Move the lock handle from the locking mechanism towards the right to lock the bracket in place. 5. Route the optical drive's power and data cables through the routing guide on the bracket. 6. Route the hard-drive power and SATA cables through the routing guide on the lock. Next steps 1. Install the 2.5/3.5-inch hard-drive caddy. 2. Install the front bezel. 3. Install the side cover. 4. Follow the procedure in after working inside your computer. Removing the slim optical-drive Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. Removing and installing components 31