Dell OptiPlex 7090 Small Form Factor Service Manual - Page 38
Fan and heat-sink assembly, Removing the fan and heat-sink assembly
View all Dell OptiPlex 7090 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
5. Follow the procedure in after working inside your computer. Fan and heat-sink assembly Removing the fan and heat-sink assembly Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. 3. Remove the front bezel. About this task The following images indicate the location of the fan and heat-sink assembly and provide a visual representation of the removal procedure. Steps 1. Disconnect the fan cable from the connector on the system board. 2. Loosen the four captive screws that secure the fan and heat-sink assembly to the system. 3. Lift the fan assembly from the system. Installing the fan and heat-sink assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the fan and heat-sink assembly and provides a visual representation of the installation procedure. 38 Removing and installing components