Dell OptiPlex 7090 Small Form Factor Service Manual - Page 52
Installing the power-supply unit
View all Dell OptiPlex 7090 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Steps 1. Remove the optical-drive SATA cables from the retention clip on the support bracket. 2. Remove the two screws (M6X32) and slide the support bracket out from the slot. 3. Disconnect and unroute the power-supply cable from the routing guides on the chassis. 4. Remove the three screws (M6X32) that secure the power-supply unit to the chassis. 5. Press down on the securing clip to release the power supply from the chassis. 6. Slide and lift the power supply from its slot on the chassis. Installing the power-supply unit Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the power-supply unit and provides a visual representation of the installation procedure. 52 Removing and installing components