Garmin RINO 520 Owner's Manual - Page 26
Setup Tones, Setup Scanlist
UPC - 753759049072
View all Garmin RINO 520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Unit Operation > Radio Page Setup Tones Call Tone-When the Call button is pressed, an attention tone is transmitted. This option allows you to choose one of 10 tones. Roger Tone-When the Talk button is released, a tone is sent to Setup Tones Page signify the end of the transmission. This option allows you to choose one of four tones, or set the tone to Off. Ring Tone-When an incoming transmission is received, an attention tone will sound. This option allows you to choose one of 10 tones or set the tone to Off. The Ring tone will not sound again until there has been 45 seconds of radio inactivity. Vibrate-Choose from On or Off to have the unit vibrate when an incoming transmission is received. Once received, the unit will not vibrate again until there has been 45 seconds of radio inactivity. The unit also vibrates at Power On when set to do so. 16 Message Beep-Choose from 19 options or Off to have the unit emit a tone when a message or note is received. Key Beep-Choose from four tones or Off to emit a tone when a key is pressed. Power Beep-Enable or disable the tone the unit makes when it is turned on and off. Turn Warning (Early)-Choose from 19 tones or Off to signal an upcoming turn on a route. Turn Warning (Final)-Choose from 19 tones or Off to signal the final turn on a route. A "Set Quiet Mode" is available to mute all tones using the Option Menu. Setup Scanlist Refer to "Scanning and Monitoring" for complete information about this feature and the options in this page. Setup Scanlist Page Rino® 520/530 Owner's Manual