HP 300X HP Jetdirect Print Server Administrator's Guide (300x, 510x) - Page 70
Table 7.2, General HP Jetdirect Messages 2 of 10 - jetdirect reset dhcp
UPC - 882780300842
View all HP 300X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Table 7.2 General HP Jetdirect Messages (2 of 10) Message Description CONFIGURATION ERROR The configuration information for the NetWare functions is not stored correctly on the HP Jetdirect print server. Rerun the installation software to reconfigure. If this error persists, there may be a problem with the HP Jetdirect print server. CRC ERROR Check the network topology and verify all cable segments. Check for damaged cables. DHCP NACK After several attempts, the DHCP server has failed to acknowledge the configuration. The Jetdirect print server will restart the configuration process. DISCONNECTED The Novell NetWare protocol is disconnected. Check the server and the print server. DISCONNECTING FROM SERVER The server has been shut down because of a configuration change or reset request. This message automatically clears after a few seconds, unless the printer is offline, is in an error state, or is servicing another I/O port or another network protocol. DISCONNECTING - SPX TIMEOUT The SPX connection to the print server was lost after the connection had been made. This indicates a possible network problem, or a problem with the print server. Make sure all cables and routers are functioning correctly. Try restarting the print server. DUP NODE ADDRESS The HP Jetdirect print server found another station on the ring that already has the address which the HP Jetdirect print server wishes to use. Make sure that all addresses are unique. ERR NEGOTIATING BUFFER SIZE A failure was detected when selecting the buffer size to be used when reading print data from the file server. This may indicate a network problem. FAIL RESERVING PRINTER NUM FRAMING ERROR When the HP Jetdirect print server is configured for multiple file servers, the error is only displayed on the configuration page if none of the file servers was successfully connected. The SPX connection to the print server was lost when the HP Jetdirect print server attempted to reserve the printer number. This indicates a possible network problem, or a problem with the print server. Make sure all cables and routers are functioning correctly. Try restarting the print server. Check the network topology and verify all cable segments. Check for damaged cables. 70 HP Jetdirect Configuration Page Messages ENWW