HP 300X HP Jetdirect Print Server Administrator's Guide (300x, 510x) - Page 76
Table 7.2, General HP Jetdirect Messages 8 of 10 - firmware download
UPC - 882780300842
View all HP 300X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Table 7.2 General HP Jetdirect Messages (8 of 10) Message Description PSERVER CLOSED CONNECTION The print server requested a termination of the connection with the HP Jetdirect print server. No error exists or is indicated. Make sure the print server is running, and restart it if necessary. READY The HP Jetdirect print server has successfully connected to the server and is awaiting data. RECEIVE BUFFER ERROR Run the power-on self-test: turn the print server off, then on again. If the error persists, replace the HP Jetdirect print server. RETRY ERROR Check the Ethernet cable. Make sure your HP Jetdirect print server is correctly attached to your network. SQE ERROR Run the power-on self-test: turn the print server off, then on again. If the error persists, replace the HP Jetdirect print server. TFTP IN PROGRESS The HP Jetdirect print server is currently in the process of obtaining its basic IP configuration information through TFTP and has not detected any errors. TFTP LOCAL ERROR The TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed with the local print server encountering some form of inactivity timeout, or excessive retransmissions situation. TFTP REMOTE ERROR The TFTP transfer of the configuration file from the host to the HP Jetdirect print server failed with the remote host sending a TFTP ERROR packet to the print server. TFTP RETRIES EXCEEDED The overall retrying of the TFTP transfer of the configuration file from the host to the HP Jetdirect print server has exceeded a retry limit. TRANSMIT ERROR Check the network topology and verify all cable segments. TRYING TO CONNECT TO SERVER The HP Jetdirect print server is trying to connect to the print server or NetWare file server after being configured. Wait for the print server to establish a connection with the print or file server. TURN PRINTER OFF/ON This message may appear after you upgrade to a new version of firmware. When this message appears, turn the print server off, then back on to enable any new functionality that was recently downloaded. 76 HP Jetdirect Configuration Page Messages ENWW