HP 8/20q HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Gui - Page 11
Command Line Interface Usage, Logging in to the switch through Telnet - fc switch
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
1 Command Line Interface Usage This section describes how to use the command line interface. NOTE: Throughout this document, references in the text to commands and keywords use initial capitalization for clarity. Actual command and operand entries are not case-sensitive. Logging in to the switch through Telnet To log in to a switch through Telnet: 1. Open a command line window on the workstation and then enter the telnet command followed by the switch Internet Protocol (IP) address: # telnet ip_address The IP address can be one of the following: • 4-byte IP version 4 (IPv4) address • 16-byte IP version 6 (IPv6) address • Domain Name System (DNS) host name (requires a DNS server) The Telnet window opens prompting you for a login. 2. Enter an account name and password. The default account name is admin, and the password is password. switch login:admin password: xxxxxxxx The following warning appears each time you log in until you change the default password. Warning: Your user account password has not been changed. It is strongly recommended that you do so before proceeding. To log off, enter the exit command: 8/20q FC Switch #> exit HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 11