HP 8/20q HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Gui - Page 219
Table 51 SNMP trap configuration parameters, Address
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 219 highlights
Operands trap [trap_number] Prompts you in a line-by-line fashion to change SNMP trap parameters for the trap number given by [trap_number]. [trap_number] can be 1-5. For each parameter, enter a new value or press Enter to accept the current value. To configure common parameters and trap parameters, omit the trap operand. Table 51 describes the trap parameters. Table 51 SNMP trap configuration parameters Parameter Trap [1-5] Address Trap [1-5] Port Trap [1-5] Severity Trap [1-5] Version Trap [1-5] Enabled Description Specifies the workstation IP address to which SNMP traps are sent. The default address for trap 1 is 10.0.0.254. The default address for traps 2-5 is 0.0.0.0. Addresses, other than 0.0.0.0, for all traps must be unique. Specifies the workstation port to which SNMP traps are sent. Valid workstation port numbers are 1-65535. The default is 162. Specifies the severity level to use when monitoring trap events. The default is Warning. Specifies the SNMP version (1 or 2) to use in formatting traps. The default is 2. Specifies whether traps (event information) are enabled (True) or disabled (False). The default is False. Examples The following is an example of the set setup snmp common command: 8/20q FC Switch (admin) #> set setup snmp common A list of attributes with formatting and current values will follow. Enter a new value or simply press the ENTER key to accept the current value. If you wish to terminate this process before reaching the end of the list press 'q' or 'Q' and the ENTER key to do so. Current Values: SnmpEnabled Contact Location ReadCommunity WriteCommunity AuthFailureTrap ProxyEnabled SNMPv3Enabled True public private False True False New Value (press ENTER to not specify value, 'q' to quit): SnmpEnabled (True / False) : Contact (string, max=64 chars) : Location (string, max=64 chars) : ReadCommunity (string, max=32 chars) : WriteCommunity (string, max=32 chars) : AuthFailureTrap (True / False) : ProxyEnabled (True / False) : SNMPv3Enabled (True / False) : Do you want to save and activate this snmp setup? (y/n): [n] HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 219