HP 8/20q HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Gui - Page 119
Modifying the SNMP configuration, common and trap-specific parameters separately. See
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Modifying the SNMP configuration To modify the SNMP configuration, enter the set setup snmp command in an Admin session. There are two groups of configuration parameters. One group is common to all traps; the second group is trap-specific. You can configure both groups of parameters for all SNMP traps, or you can configure the common and trap-specific parameters separately. See Table 50 for descriptions of the common SNMP parameters. The following example sets the common trap parameters for all SNMP traps: 8/20q FC Switch (admin) #> set setup snmp common A list of attributes with formatting and current values will follow. Enter a new value or simply press the ENTER key to accept the current value. If you wish to terminate this process before reaching the end of the list press 'q' or 'Q' and the ENTER key to do so. Current Values: SnmpEnabled Contact Location ReadCommunity WriteCommunity AuthFailureTrap ProxyEnabled SNMPv3Enabled True public private False True False New Value (press ENTER to not specify value, 'q' to quit): SnmpEnabled (True / False) : Contact (string, max=64 chars) : Location (string, max=64 chars) : ReadCommunity (string, max=32 chars) : WriteCommunity (string, max=32 chars) : AuthFailureTrap (True / False) : ProxyEnabled (True / False) : SNMPv3Enabled (True / False) : Do you want to save and activate this snmp setup? (y/n): [n] HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 119