HP 8/20q HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Gui - Page 209
set port, Table 44 Transmission speed parameters, Table 45 Port administrative state parameters
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 209 highlights
set port Description Sets port state and speed for the specified port temporarily until the next switch reset or new configuration activation. This command also clears port counters. Authority Admin session Syntax set port clear or set port [port_number] clear speed [transmission_speed] state [state] Operands [port_number] Specifies the port. Ports are numbered beginning with 0. clear Clears the counters on all ports or the port given by [port_number]. speed [transmission_speed] Specifies the port transmission speed. Table 44 describes the transmission speed parameters. Table 44 Transmission speed parameters Parameter 2Gb/s 4Gb/s 8Gb/s Auto Description The port speed is 2 Gb/s. The port speed is 4 Gb/s. The port speed is 8 Gb/s. The port speed is automatically detected. state [state] Specifies the port administrative state. Table 45 describes the port administrative state parameters. Table 45 Port administrative state parameters Parameter Online Offline Diagnostics Down Description Activates and prepares the port to send data Prevents the port from receiving signal and accepting a device login Prepares the port for testing and prevents the port from accepting a device login Disables the port by removing power from the port lasers Notes QuickTools and Enterprise Fabric Management Suite override any temporary administrative state changes that have been made using the Set Port State command. Therefore, to avoid unexpected results, do not manage port administrative states with QuickTools or Enterprise Fabric Management Suite and the CLI at the same time. See also show port, page 259 HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 209