HP 8/20q HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Gui - Page 117
Simple Network Management Protocol Configuration, Managing the SNMP service - storageworks default password
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
12 Simple Network Management Protocol Configuration The Simple Network Management Protocol (SNMP) provides for the management of the switch through third-party applications that use SNMP. Security consists of a ReadCommunity string and a WriteCommunity string that serve as passwords that control read and write access to the switch. These strings are set at the factory to well-known defaults and should be changed if SNMP is to be enabled. The switch supports SNMP version 3 in the CLI, which is disabled by default. Managing the SNMP service You control the SNMP service SNMPEnabled parameters through the set setup snmp or set setup services commands. See "Modifying the SNMP configuration" (page 119). To enable SNMP, enter the set setup services command, as shown in the following example: 8/20q FC Switch #> admin start 8/20q FC Switch (admin) #> set setup services A list of attributes with formatting and current values will follow. Enter a new value or simply press the ENTER key to accept the current value. If you wish to terminate this process before reaching the end of the list press 'q' or 'Q' and the ENTER key to do so. PLEASE NOTE Further configuration may be required after enabling a service. * If services are disabled, the connection to the switch may be lost. * When enabling SSL, please verify that the date/time settings on this switch and the workstation from where the SSL connection will be started match, and then a new certificate may need to be created to ensure a secure connection to this switch. TelnetEnabled SSHEnabled GUIMgmtEnabled SSLEnabled EmbeddedGUIEnabled SNMPEnabled NTPEnabled CIMEnabled FTPEnabled MgmtServerEnabled CallHomeEnabled (True / False) (True / False) (True / False) (True / False) (True / False) (True / False) (True / False) (True / False) (True / False) (True / False) (True / False) [True ] [False] [True ] [False] [True ] [True ] [False] [False] [True ] [True ] [True ] Do you want to save and activate this services setup? (y/n): [n] You can display the SNMPEnabled parameters using the show setup snmp or show setup services commands. HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 117