HP 8/20q HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Gui - Page 181
set log, hardreset, hotreset, Table 24, IPv4 Ethernet
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 181 highlights
switch Resets the switch without a power-on self test (POST). This is the default. This reset disrupts traffic and does the following: • Activates the pending firmware • Closes all management sessions • Clears the event log. To save the event log before resetting, see the "set log" (page 205). To reset the switch with a power-on self test, see the "hardreset" (page 154). To reset the switch without disrupting traffic, see the "hotreset" (page 157). NOTE: The following files are deleted from the switch during a switch reset: • Firmware image files that have not been unpacked • Configuration backup files • Support files system Resets the following system configuration settings to the factory default values: • DNS host (Table 24) • IPv4 Ethernet (Table 25) • IPv6 Ethernet (Table 26) • Event logging (Table 27) • NTP (Table 28) • Timers (Table 29) NOTE: Because this operand changes network parameters, the workstation could lose communication with the switch. This operand does not affect installed license keys. zoning Clears the zoning database and deactivates the active zoneset. The zoning configuration parameters (MergeAutoSave, DefaultZone, DiscardInactive) remain unchanged. See Table 20 for information about the zoning configuration parameters. HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Guide 181