HP 8/20q HP StorageWorks 8/20q Fibre Channel Switch Command Line Interface Gui - Page 222
Table 53 IPv4 Ethernet configuration parameters, RARP Reverse Address Resolution Protocol
View all HP 8/20q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 222 highlights
ipv4 Prompts you in a line-by-line fashion to change the switch IPv4 Ethernet configuration parameters described in Table 53. To configure all system parameters, omit the operand. For each parameter, enter a new value or press Enter to accept the current value. NOTE: Changing the IP address will terminate all Ethernet management sessions. Table 53 IPv4 Ethernet configuration parameters Parameter Description EthIPv4NetworkEnable Enables (True) or disables (False) the IPv4 interface. The default is True. EthIPv4NetworkDiscovery Ethernet boot method: • 1-Static • 2-Bootp (Bootstrap Protocol) • 3-DHCP (Dynamic Host Configuration Protocol) • 4-RARP (Reverse Address Resolution Protocol) The default is 1-Static. EthIPv4NetworkAddress Ethernet IP address. The default is 10.0.0.1. EthIPv4NetworkMask Ethernet subnet mask address. The default is 255.0.0.0. EthIPv4GatewayAddress Ethernet IP address gateway. The default is 10.0.0.254 Operands ipv6 Prompts you in a line-by-line fashion to change the switch IPv6 Ethernet configuration parameters described in Table 54. To configure all system parameters, omit the operand. For each parameter, enter a new value or press Enter to accept the current value. NOTE: Changing the IP address will terminate all Ethernet management sessions. Table 54 IPv6 Ethernet configuration parameters Parameter Description EthIPv6NetworkEnable Enables (True) or disables (False) the IPv6 interface. The default is True. EthIPv6NetworkDiscovery Ethernet boot method: • 1-Static • 2-DHCPv6 (Dynamic Host Configuration Protocol) • 3-NDP (Neighbor Discovery Protocol) The default is Static. EthIPv6NetworkAddress Ethernet IP address EthIPv6GatewayAddress Ethernet IP address gateway. 222 Command Reference