HP DL760 HP ProLiant DL760 Generation 2 Server User Guide - Page 182

Server Power System Power Overview The system power in the ProLiant DL760 G2 server does not shut off completely with the front panel Power On/Standby switch. The two modes of the power switch are on and standby, rather than on and off. The Standby position removes power from most of the electronics and the drives, but portions of the power supply, the IMD, the system interlock circuitry, and some internal circuitry remain active. To remove all power from the system completely, you must disconnect all power cords from the server. WARNING: To reduce the risk of electric shock or damage to the equipment: • Disconnect power from the system by unplugging all power cords from the power supplies. • Do not disable the power cord grounding plug. The grounding plug is an important safety feature. • Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times. WARNING: The power supplies in the ProLiant DL760 G2 server produce hazardous energy levels. The installation of options and the routine maintenance and service of this product should be performed by individuals who are knowledgeable about the procedures, precautions, and hazards associated with equipment containing hazardous energy circuits. CAUTION: Electrostatic discharge can damage electronic components. Be sure that you are properly grounded before beginning any installation procedure. Refer to Appendix B for more information. NOTE: All ProLiant servers support server management features that provide in-depth monitoring, analysis, and control of the fault performance and configuration aspects of HP servers. Refer to your system Documentation CD for information about server management features, Flash ROM, and Insight Manager 7. 7-2 HP ProLiant DL760 Generation 2 Server User Guide