HP DL760 HP ProLiant DL760 Generation 2 Server User Guide - Page 29
PCI Hot Plug, Network Interface Controller, A PCI Hot Plug button is located above each PCI/PCI-X slot - proliant g2 documentation
UPC - 613326397428
View all HP DL760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Server Features PCI Hot Plug PCI Hot Plug provides the ability to remove, replace, upgrade, and add PCI/PCI-X expansion boards without powering down the server. PCI and PCI-X boards can be placed in a PCI Hot Plug slot. PCI Hot Plug device drivers and operating system support are required to enable PCI Hot Plug. A PCI Hot Plug button is located above each PCI/PCI-X slot, providing PCI Hot Plug control directly at the server without the use of the PCI Hot Plug utility software. For more information about PCI Hot Plug, refer to the server Documentation CD. Network Interface Controller The ProLiant DL760 G2 server ships with an NC7770 PCI-X Gigabit NIC pre-installed in slot 11. This 10/100/1000 Base TX UTP, 64-bit, 133-MHz PCI-X NIC includes the following features: • One RJ-45 connector for 10BaseT, 100BaseTX, or 1000BaseTX Ethernet • Pre-boot eXecution Environment (PXE) support For information about the NIC, refer to the HP website: www.hp.com Redundant NIC software, located on the SmartStart CD, supports a redundant NIC configuration. This feature may be used with one dual-port, two single-port, or two dual-port NICs. 1-12 HP ProLiant DL760 Generation 2 Server User Guide