HP DL760 HP ProLiant DL760 Generation 2 Server User Guide - Page 98

Installing Hardware Options, Server Power Off The I/O expansion slots are distributed among one PCI bus and five separate PCI-X buses. NOTE: It is recommended that you install the optional RILOE II board into slot 9. NOTE: Each PCI-X bus will automatically configure to run in the most advanced mode (PCI-X or PCI) and the highest frequency supported by all expansion boards installed in the slots on the bus. NOTE: The ProLiant DL760 G2 server ships with a NIC preinstalled in slot 11. Adding Non-Hot-Plug Expansion Boards You can use non-hot-plug expansion boards in the ProLiant DL760 G2 server, but you must install them according to the following procedure. To prepare the server: 1. If this is the first time you have powered up the server, skip to step 4. If you have previously powered up the server, back up all data on the server. 2. Shut down the operating system as directed in your operating system instructions. 3. Power down the server (refer to Chapter 7). 4. Disconnect the power cords from the server. 5. Slide the server out of the rack. 6. Open the I/O lid as shown in Chapter 3. HP ProLiant DL760 Generation 2 Server User Guide 4-9