HP Integrity rx8620 HP Insight Manager WBEM Provider Events Reference - Page 90
allowed. Probable Cause: Improper configuration Recommended Action: Check
View all HP Integrity rx8620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Event ID Event Severity Event Description 11597 Warning ArfRouteEnable() returned an unexpected error while enabling routes to the local cell. Data field: (local cell number 56) | (bitmap of routes to enable). Probable Cause: An error occurred while routing the fabric. Recommended Action: Collect IPMI event logs, and contact your HP support representative to inspect the fabric and system firmware. WBEM EventID: 4951. WBEM ProviderName: FPL_IndicationProvider 11598 Warning ArfRouteDiable() returned an unexpected error while disabling routes during an OLA operation. Data field: (bitmap of cells 32) | (bitmap of routes to disable). Probable Cause: An error occurred while routing the fabric. Recommended Action: Collect IPMI event logs, and contact your HP support representative to inspect the fabric and system firmware. WBEM EventID: 4952. WBEM ProviderName: FPL_IndicationProvider 11599 Warning ArfRouteDiable() returned an unexpected error while disabling routes in ArfPhase4. Data field: (bitmap of source cells 32) | (bitmap of routes to disable). Probable Cause: An error occurred while routing the fabric. Recommended Action: Collect IPMI event logs, and contact your HP support representative to inspect the fabric and system firmware. WBEM EventID: 4953. WBEM ProviderName: FPL_IndicationProvider 11603 Error Memory allocation failed. The data is the size of the memory block which could not be allocated. Probable Cause: Memory could not be allocated for the guest. Recommended Action: Reduce memory usage by other programs, add physical memory, verify sufficient swap space, or configure the guest to use less memory. WBEM EventID: 4957. WBEM ProviderName: FPL_IndicationProvider 11604 Error Memory locking failed. The data is the size of the memory block which could not be locked. Probable Cause: This can be caused by insufficient physical memory. Recommended Action: Reduce memory usage by other programs, add physical memory, or configure the guest to use less memory. WBEM EventID: 4958. WBEM ProviderName: FPL_IndicationProvider 11605 Error The minimum number of processors required is more than the number available. The data is the number of available processors. Probable Cause: The number of physical processors is too few to run the guest as configured. Recommended Action: Add processors or reconfigure the guest to use fewer processors. WBEM EventID: 4959. WBEM ProviderName: FPL_IndicationProvider 11607 Error The guest operating system performed an operation which could not be handled by the virtual machine. The virtual machine could not continue running the guest so it stopped. Probable Cause: The guest detected an error and could not continue. Recommended Action: See the HPVM guest operation log for additional information. WBEM EventID: 5133. WBEM ProviderName: FPL_IndicationProvider 11696 Error Kernel driver failed to lock memory. Probable Cause: Kernel driver was unable to lock memory pages Recommended Action: Possibly insufficient physical memory. Add memory or reduce size of guest. WBEM EventID: 5134. WBEM ProviderName: FPL_IndicationProvider 11700 Error The code which initializes the MMIO/IOP map found that the table already contained information. Probable Cause: An incorrect calling sequence has occurred or an image is corrupt. Recommended Action: If this continues to occur, reinstall the software. If this does not fix the problem contact your HP support representative. WBEM EventID: 5135. WBEM ProviderName: FPL_IndicationProvider 11702 Error An attempt was made to add a PCI bus with a number greater than the maximum allowed. Probable Cause: Improper configuration Recommended Action: Check the configuration and set all bus numbers to supported values. WBEM EventID: 5136. WBEM ProviderName: FPL_IndicationProvider 11703 Error The configured CPU generation is not supported. Probable Cause: The configuration contains an unsupported CPU generation Recommended Action: Modify the configuration to use a supported CPU generation WBEM EventID: 5137. WBEM ProviderName: FPL_IndicationProvider 90 WBEM Provider Event Tables