HP Integrity rx8620 HP Insight Manager WBEM Provider Events Reference - Page 95

Event ID Event Severity Event Description 12025 Warning An error encountered while retrieving the expected neighbor fabric chip for distributing traffic over crossbar links. Probable Cause: Unexpected error retrieving information from the fabric graph. Recommended Action: Collect IPMI event logs and contact your HP Support Representative to investigate the fabric system firmware subsystem WBEM EventID: 5189. WBEM ProviderName: FPL_IndicationProvider 12028 Warning Could not read crossbar neighbor information during routing. Probable Cause: System Firmware encountered an error while reading a fabric crossbar chip. Recommended Action: Collect IPMI Event Logs and contact your HP Service Representative to investigate the fabric subsystem. WBEM EventID: 5190. WBEM ProviderName: FPL_IndicationProvider 12029 Warning Could not establish route for local crossbar during route around routing. Probable Cause: System Firmware could not establish routing from the local crossbar that would be needed to complete the route around routing. Recommended Action: Collect IPMI Event Logs and contact your HP Support Representative to investigate the fabric subsystem. WBEM EventID: 5191. WBEM ProviderName: FPL_IndicationProvider 12047 Error An invalid or non-supported TPM (Trusted Platform Module) has been detected. Ensure that the TPM is fully seated into the system board and verify the operating system is TPM capable. Probable Cause: An invalid, non supported TPM is being used in the system Recommended Action: Contact HP for support WBEM EventID: 5193. WBEM ProviderName: FPL_IndicationProvider 12048 Warning Invalid or unsupported TPM detected in the system. TPM is disabled. Probable Cause: An invalid or unsupported TPM has been detected in the system. TPM is disabled. Recommended Action: Contact HP support WBEM EventID: 5194. WBEM ProviderName: FPL_IndicationProvider 12049 Warning TPM failed initialization. Security features disabled. Probable Cause: Bad TPM chip Recommended Action: contact HP support WBEM EventID: 5195. WBEM ProviderName: FPL_IndicationProvider 12050 Error A CPU module's temperature has exceed the high temperature threshold or a CPU power module fault has occurred. As a result of this event, the CPU has been inhibited. The Cell must be powered off then on using the MP's PE command to clear. Probable Cause: A CPU module's temperature has exceed the high temperature threshold or a CPU power module fault has occurred. Recommended Action: Contact HP support personnel to troubleshoot the problem. WBEM EventID: 5192. WBEM ProviderName: FPL_IndicationProvider 12069 Warning SFW detected an error while writing to stable store flash. Probable Cause: Cosmic radiation Bad flash part Recommended Action: Reboot, if problem persists, contact HP support WBEM EventID: 6861. WBEM ProviderName: FPL_IndicationProvider 12091 Warning PCI interlock open with PCI power applied. Probable Cause: PCI interlock has been opened with PCI slot power on. Recommended Action: power down slot attempting to remove PCI card. WBEM EventID: 5230. WBEM ProviderName: FPL_IndicationProvider 12101 Error Fault detected on low drop out regulator on I/O backplane. Probable Cause: A defective component could cause this fault. Recommended Action: Check the backplane. WBEM EventID: 5237. WBEM ProviderName: FPL_IndicationProvider 12102 Error Fault detected on low drop out regulator on main backplane. Probable Cause: The specified low dropout regulator on the main backplane is reporting a fault. Recommended Action: Check the main backplane. WBEM EventID: 5238. WBEM ProviderName: FPL_IndicationProvider 12103 Error Fault detected hot swap controller of specified core IO. Probable Cause: The hot swap controller for the specified core IO is reporting fault. Recommended Action: Check the specified core IO. WBEM EventID: 5250. WBEM ProviderName: FPL_IndicationProvider Platform Events 95