HP Integrity rx8620 Installation Guide, Sixth Edition - HP Integrity rx8620 Se - Page 52
Removing the Side Cover, Step 1.
View all HP Integrity rx8620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Installation Wheel Kit Installation Removing the Side Cover Figure 2-16 Side Cover Detail Retaining Screw Step 1. Connect to ground with a wrist strap. Step 2. Loosen the blue retaining screw securing the cover to the chassis. See Figure 2-16. Step 3. Slide the cover from the chassis toward the rear of the system. Step 4. Place the cover in a safe location. Installing the Side Cover Step 1. Orient the cover according to its position on the chassis. Step 2. Slide the cover into position using a slow, firm pressure to properly seat the cover. Step 3. Tighten the blue retaining screw securing the cover to the chassis. 52 Chapter 2
Chapter 2
Installation
Wheel Kit Installation
52
Removing the Side Cover
Figure 2-16
Side Cover Detail
Step 1.
Connect to ground with a wrist strap.
Step 2.
Loosen the blue retaining screw securing the cover to the chassis. See Figure 2-16.
Step 3.
Slide the cover from the chassis toward the rear of the system.
Step 4.
Place the cover in a safe location.
Installing the Side Cover
Step 1.
Orient the cover according to its position on the chassis.
Step 2.
Slide the cover into position using a slow, firm pressure to properly seat the cover.
Step 3.
Tighten the blue retaining screw securing the cover to the chassis.
Retaining Screw