HP Integrity rx8620 Installation Guide, Sixth Edition - HP Integrity rx8620 Se - Page 55

Embedded Disks, Hard Disk Drive Installation, Removable Media Drive Installation

Get HP Integrity rx8620 PDF manuals and user guides View all HP Integrity rx8620 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 55 highlights

Installation Installing Accessories A list of replacement disk drives for the HP Integrity rx8620 Server is in Appendix A of the Service Guide for the HP Integrity rx8620 Server. The list contains both removable media disk drives and hard disk drives. Figure 2-17 Embedded Disks Hard Disk Drive Installation The disk drives are located in the front of the chassis. The hard disk drives are hot-plug drives. Step 1. Be sure the front locking latch is open, then position the disk drive in the chassis. Step 2. Slide the disk drive into the chassis; a slow, firm pressure is needed to properly seat the connector. Step 3. Press the front locking latch to secure the disk drive in the chassis. Step 4. Spin up the disk by entering one of the following commands: #diskinfo -v /dev/rdsk/cxtxdx #ioscan -f Removable Media Drive Installation The DVD drive or DDS-4 tape drive is located in the front of the chassis. The server power must be turned off before attempting to install it. Refer to "Shutting Down nPartitions and Powering Off Hardware Components" in the Service Guide for the HP Integrity rx8620 Server for more information. If an upper drive is installed, it will need to be removed before installing a lower drive. Step 1. Remove filler panel. Chapter 2 55

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
Chapter 2
Installation
Installing Accessories
55
A list of replacement disk drives for the HP Integrity rx8620 Server is in Appendix A of the Service Guide for
the HP Integrity rx8620 Server. The list contains both removable media disk drives and hard disk drives.
Figure 2-17
Embedded Disks
Hard Disk Drive Installation
The disk drives are located in the front of the chassis. The hard disk drives are hot-plug drives.
Step 1.
Be sure the front locking latch is open, then position the disk drive in the chassis.
Step 2.
Slide the disk drive into the chassis; a slow, firm pressure is needed to properly seat the connector.
Step 3.
Press the front locking latch to secure the disk drive in the chassis.
Step 4.
Spin up the disk by entering one of the following commands:
#diskinfo -v /dev/rdsk/cxtxdx
#ioscan -f
Removable Media Drive Installation
The DVD drive or DDS-4 tape drive is located in the front of the chassis. The server power must be turned off
before attempting to install it. Refer to “Shutting Down nPartitions and Powering Off Hardware Components”
in the Service Guide for the HP Integrity rx8620 Server for more information.
If an upper drive is installed, it will need to be removed before installing a lower drive.
Step 1.
Remove filler panel.