HP Surestore 80fx Optical Drive and Library SCSI-2 Command Reference - Page 169

NOTE SCSI-2 Drive Command Set Write (Group 5) Command (AAH) FUA Rel Adr EBP Transfer Length PBA ErsCntl A Force Unit Access bit of 1 indicates that data is written directly to the disk. An FUA bit of 0 indicates that write caching will be allowed. A relative address bit of one indicates that logical block address specified is a two's complement offset from the last logical block address accessed. A value of 0 indicates that the logical block address is an absolute address. If the Erase By-Pass bit is set to 0, an erase is automatically performed before writing the data. An EBP bit of 1 suppresses the erase operation. The Transfer Length field indicates the number of contiguous logical blocks to be transferred for this command. A value of 0 indicates that no blocks will be transferred and is not considered an error. A Physical Block Address bit of 1 indicates that physical block addressing is used. A PBA bit of 0 indicates that logical block addressing is used. The Erase Control bit is identical to the Erase Bypass bit. The 9.1 and 5.2 Gbyte capacity drives cannot Format, Erase, Write, or Write and Verify 650 Mbyte and 1.3-Gbyte optical disks. The 2.6 Gbyte capacity drives cannot Format, Erase, Write, or Write and Verify 650 Mbyte optical disks. If this command is issued with any of these drive/ media combinations, a CHECK CONDITION status will result with the Sense Key/Additional Sense Code set to Data Protect/Write Protected. 2-132 Chapter 2