HP Surestore 80fx Optical Drive and Library SCSI-2 Command Reference - Page 335

Autochanger Error Codes Jukebox Micro-Move Error Codes Table B-13 Sequence Tests (For models 40fx, 80ex, 125ex, and 220mx ONLY) No. Test Name Description 23 Shipping Moves the picker to the appropriate position in preparation for shipping. 24 Fill Picker Moves a cartridge into the picker from the first full storage slot. 25 Empty Picker Moves a cartridge from the picker to the first empty storage slot. 26 Zero Runtime Log The entire runtime log is initialized to all zeros. 27 Set Minimum Retries This sets the number of retries to 1. This may be set to see if the chosen test is doing what you want it to do. After you are satisfied that the test is what you want, run Test 28 which resets the number of retries to default values. 28 Set to Default Number Resets the number of retries to powerup default of Retries values. Used after setting retries to 1 by Test 27. 29 Zero Error Log Sets Information Log 0, Autochanger Error Log back to zero. Electronic Core Tests 30 Microprocessor Operation Test Performs a functional check of the microprocessor. This test will shut down the servo system; a poweron sequence runs upon completion. 31 ROM Checksum Test Performs a checksum verification of the ROM. 32 RAM Checksum Test A checksum of the "Controlled" area of RAM is kept on an ongoing basis. This test verifies that the checksum is still valid. 33 Non-Destructive RAM Tests all of the controller's RAM, checking for Test data acceptance and retention. The test is non- destructive to RAM unless interrupted by power failure. This test will shut down the servo system; a poweron sequence runs upon completion. B-48 Appendix B